Skateboard Wall Mount Hooks

Noted: 1 set of 2 packs.

• Size: 4.13" x 2.76" x 2.56" (10.5cm x 7cm x 6.5cm)         
• Strong enough to hold 40lbs or more when properly installed.

Installation Steps:

(On the Gypsum Board)

• Mark the center of two holes on the Gypsum Board (approximately 55mm apart).
• Put about 1/3 of the Thread Screw into the Gypsum Board mark.
• Screw the Thread Screw into Gypsum Board deeply with screwdriver.
• Aim the hook at the wall expansion screw ,then screw the standard screw into the expansion tube for fixation with screwdriver.

(on Wooden Keel,Brick Wall and Concrete)

• Mark the center of two holes on the surface of the wall (approximately 34.5mm apart).
• Use the electric drill to make two hole on the wall.
• Use the hammer to drive the expansion pipe into the hole.
• Aim the hook at the wall expansion screw ,then screw the standard screw into the expansion tube for fixation with screwdriver.